Before & After Photos

This homeowner in Salem, CT called us out to their home for a Home Energy Evaluation. During our Attic walkthrough portion of the visit we noticed they had old, nasty fiberglass insulation and mold in their attic! Mold in your attic is not normal, and it is for sure not healthy. It means there is another problem in your home that is causing relative humidity in your home to go above 75% so mold can grow on wood and insulation. We can treat the home and prevent more mold from growing, but can we eliminate the mold that is already there? YES we can!

We use our Mold-X Neutralizer which kills all mold spores and stops the future growth. We spray this in the attic and make sure it reached all nooks and crannies where mold may grow. the mold is still visible, but it is dead. Next we use out Mold-X botanical to clean the mold stains off of any surface. 

In the photo you can see the black mold, and old insulation, in the after photo you can see old insulation is removed, and we have started out air sealing and insulation process as well.

Now, thanks to Dr. Energy Saver by Eco Energy Solutions this home is now safe environment!

Our team Insulated this basement with Foamax "polyiso" insulation boards

These homeowners in Lebanon, CT were worried about their pipes freezing. If the basement and crawlspace are not sealed and insulated, heat coming off of the furnace or boiler is lost through leaks as well as by conduction through block walls.

To start, we sealed the rim joist with spray foam and addressed any air leaks. We then secured our SilverGlo foam to the walls to prevent any more loss of heat. SilverGlo is infused with graphite and has a reflective radiant barrier to keep in heat in the winter. For the portion of the home that was crawlspace, we made sure to address the dirt floor under that old tarp which we removed. We put down a dimpled matting to keep an air break, then TerraBlock floor insulation, and finally our vapor barrier to keep any moisture from getting up into the home.

Thanks to Dr. Energy Saver by Eco Energy Solutions, these homeowners can have peace of mind by not having to worry about losing heat or having their pipes freeze when winter rolls in.

Cathedral ceiling was dramatically uninsulated. Fogarty's Home Services removed the ridge vent and inserted a long fill tube to reach the bottom of the ceiling plane, and "dense packed" into each rafter bay filling all air spaces. After Completion of insulation We installed hip and ridge cap shingles and a Tribuilt Omni Ridge pro - ridge vent to finish the job. 

This homeowner was experiencing severe ice damming.  Ice damming occurs when heat from inside your attic warms the underside of your roof. This causes the snow and ice on the roof to melt. When the water hits the cold gutter and overhang, it refreezes and forms an ice dam and icicles. Ice damming causes a lot of damage to homes.  Our team went to work on this homeowner's attic.  We air sealed all the penetrations and tops of the walls with our 1-Part Expandable Polyeuranem Foam.  We blew our TruSoft Cellulose insulation to a Department of Energy recommendation of R-60, which is about 18 to 20 inches.  This attic is now properly air sealed and insulated.  The homeowner is very happy to no longer have to worry about ice dams!